NPXL V2 LED Strip PCB Holder - Hilt Side - 1" - LONG PINS

NPXL V2 LED Strip PCB Holder - Hilt Side - 1" - LONG PINS

Regular price £3.00

Here is the ShtokCustomWorx NPXL V2 LED Strip PCB Holder. This is the hilt side and for 1" emitters. It is also designed for the long pins option only.
Machined from black ABS. It is not compatible with any third party PCB.
This holder is MagConnect compatible. Magnets are sold separately here.
Please note, the magnets are a snug interference fit. They will still need be glued in so the force of the magnets do not pull them out when near each other. We recommend a low viscosity CA glue for this.
Be careful when doing this; the magnets are fragile. Also, it is important to note that due to the tolerances, be sure to check the fitting of the holder inside the hilt before the magnets have been put it and after. The addition of the magnets may expand the holder slightly resulting in a tighter fit. If this is the case, we recommend lightly sanding the outside of the magnets using a sanding drum to reduce the outer diameter slightly. This will stop the holder from expanding after installing the magnets.
Note that the PCB is press fit but it can be further secured using a small dab of hot glue or equivalent. It does also have 2 holes on each side of the holder should you wish to tap them and secure the PCB using screws.

Please be sure that before ordering, you are fully aware of the shipping policies outlined here: https://thesaberarmory.com/shipping-policies/

Terms and Conditions

Open tab
Close (esc)

JOIN OUR MAILING LIST!

Sign up to our mailing list below to hear about all of the new products and offerings by The Saber Armory.

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Search

Shopping Cart

Your cart is currently empty.
Shop now
Rewards
Rewards